A Guide to Interior Detailing
This is the third of our Attention To Detail blogs and now that we have covered Detailing Preparation and Exterior Detailing we move on to the interior of the car.
We will again break the broad topic of interior detailing down into steps so it is easier to follow and if time isn’t a luxury you can afford, you can pick and choose which steps you have time for and which need to be left for another time.
We will be looking at:
- Rubbish Removal
- Carpets and Mats
- Dashboard and Center Console
Cars can, of course, be valeted by a company but they don’t always clean and detail the car to the level you want and expect from a professional firm, so for instances like that it is worth having a read about what is required and the techniques used to detail a car to the high standard you want. A lot of it depends on how much time you have free and if you have the know-how.
To detail the interior of your car you are going to need the recommended products we mentioned in the preparation blog, as listed again below:
- Vacuum cleaner, brush and carpet shampoo.
- Black & Decker Dustbuster 12 Volt Car Vacuum
- Interior trim protector.
- Autoglym Vinyl and Rubber Care
- Scotchgard Protector for Fabrics & Upholstery
- Quick Finish Interior
- Leather cleaner and leather cleaning brush.
- L1 Leather Guard
- Turtle Wax Glycerin Enriched Leather Cleaner & Conditioner
- Leather Cleaner
- Alcantara leather, it is best to use a diluted surface cleaner and a soft bristle brush.
- Alcantara Cleaner
- I1 Smart Fabric
- Swissvax Alcanta Cleaner
- Microfibre cloth.
- Kent Q6100 Extra Large Microfibre Drying Towel
- MF2 Zero Scratch Microfibre Drying Towel
- Micro Fluffy Anthracite
- Fabric treatment shampoo.
- Hi-Foam Interior Shampoo
- Swissvax Fabric
- Fabric Interior Care Kit
1. Rubbish Removal
This is exactly what it says on the tin. Gut the car of all litter and bits of obvious dirt and rubbish that is lying around. Slide the seats to the maximum forward position to check under them and then slide them to the maximum rearward position to check again. It is such an obvious step to detailing your car but removing any rubbish inside instantly makes it look smarter and much more inviting to sit in.
2. Carpets and Mats
Once all of the obvious rubbish has been removed the next step is cleaning the carpets and mats. It is best to remove the parcel shelf, any floor mats or seat covers you may have first as any dirt on them can fall onto the carpet-or you may just miss the dirt under them all together.
The same rule of thumb applies yet again, start from the top and work down. clean the parcel shelf and mats out of the car, using the vacuum cleaner and if they have marks and stains on them, carpet shampoo can be used to clean them further.
If they are rubber mats then rinse them thoroughly, once you have shampooed the fabric mats, and rinsed the rubber mats, hang them up so they can dry off.
The carpet itself needs to be shampooed to clean it-preferably spray on shampoo as it covers the area more evenly. Get a thick bristle brush and work the sprayed shampoo into the carpet one area at a time. It is best to work in section rather than spraying the whole carpet first as if it is left too long and is given time to soak in, the carpets can develop mildew. So for that reason, it is also best to have some kitchen roll as well to soak up any overly damp patches left behind after you have worked the shampoo into the carpet.
If there is a slightly heavier stain on the carpet just spray a little more shampoo or, a specific stain remover, onto that area and work it in again.
3. Dashboard and Center Console
A bottle of compressed air is recommended for this stage as you can blow out any dust and dirt that is in the harder to reach areas, have a vacuum cleaner set up next to it to act as an extractor, so you don’t end up just blowing the dirt around the car and it is removed instead.
The center console and the dashboard can be wiped down with a mild all purpose cleaner once you have blown and swept away any obvious dust and dirt. Use a spray on cleaner and wipe it over the interior surfaces. To finish the surfaces you will need an interior dressing, Armor All offer some great products so check them out, you can use them on all of the dashboard and center console, plastic and door trim and also vinyl seats.
The interior dressing really adds the last shine to your detailing efforts, so take time to make sure you protect all of the surfaces and apply it evenly. You don’t want any excess or streaky marks left behind to work the dressing into the surfaces, by the end and with continued use, your plastics and trim will look refreshed and restored.
DO NOT: Use interior dressing on the pedals, steering wheel, leather seats, or any car control and exterior features. It will make a surface slippery so avoid the areas mentioned as this jeopardizes your safety when driving.
Make sure you start off in a small test area to get a feel for it and to observe the effects before you use it any large trim surfaces.
Detailing your seats can make a big difference to the interior of your car as they are the first thing you really see as you look into the car, and they can very quickly look dull and discolored if you spill things, drop crumbs from food and just from the bleaching effect from the sun. Different materials require different methods in order to clean and detail them to a high standard.
There isn’t one set uniform method that should be used so, to make it easier, we have looked at the different methods for different seat types. Have a look below for the method that best suits your car seats.
Fabric seats are easier to clean than leather seats as they can do in the same way as the carpets. Use car interior shampoo and scrub into the fabric using a sponge. Do it in small areas and, as with the carpets, make sure you don’t soak the seats as this can lead to mildew and make the finished product look worse than before you started.
Once you have shampooed the seats use a damp micro fiber cloth to wipe them down, removing the dirt the shampoo and scrubbing should lift up, leaving a clean seat underneath. There is no harm in repeating the detailing process a number of times until you are happy all of the dirt and stains have been lifted from the seat, just make sure you don’t gradually make the seat soaking wet.
Use a cloth or soak up any moisture left on the seats once you have shampooed them. Once the cloth feels dry again after you have used it to try and soak up more moisture you have done it enough times. If it still feels wet you need to keep wiping over the seats.
Another method is to use a ‘wet-vac’ (Water Extraction Carpet Cleaner) this will give you neater lines in the material and may be more powerful than if you clean and detail by hand. It depends on how much time you have and if you are prepared to go over the seats a number of times to get the best results.
Alcantara leather is much softer than the usual, shiny, tougher leather you may be used to for car seats. It can quickly look matted and flat from use so it is important that you take your time when detailing Alcantara leather to make it look full and refreshed. It is more delicate as a result and needs more care although the method used is largely the same.
You want to start by just vacuuming any obvious dirt on the seat. Start with a small, unseen area to practice and then move on to the main body of the seat.
Using a spray ensures a much more even covering than simply wiping it onto the seats. Once you have sprayed the seat using a clean, soft bristle brush to scrub the seat. then you don’t have to apply much pressure. when you wipe it away with a micro fiber cloth it leaves a clean patch of leather underneath.
It is far better to go back over the same area a number of times, (some areas of tougher dirt may take 3 or 4 goes to properly detail them) than to scrub one area too hard and risk damaging the leather. Take your time with it and make sure you don’t soak the material, just a light film of mist over it.
The micro fiber cloth is your indicator as to whether or not you have finished each section. If there is still dirt on the cloth you need to clean the leather further.
Now that the Alcantara is clean you need to refresh it and lift it. The best and easiest way to do this is to use a vacuum cleaner again. Use the narrower nozzle attachment and run it over the leather in a smooth back and forth motions. You almost want to scrub the leather again, while not actually touching it. You are running just above it.
By following all of the steps above will able you to detail the interior of your car. Then all you have to do is look at it, admire it, and enjoy it.
want to open your own business